Search found 2 matches

Go to advanced search

by losiledlighting
Fri Jun 14, 2019 11:48 pm
Forum: Troubleshooting and Bug Reports
Topic: Can't Preview G-Code
Replies: 1
Views: 164

Can't Preview G-Code

I assume you figured this one out. Just slide the "End" slider to the right. The sliders let you show layer-by-layer or line-by-line how the printer will move, but the preview comes up with both sliders full left, which shows from the start of the print to the start of the print. Since "x minus x eq...
by losiledlighting
Wed Jun 12, 2019 3:35 am
Forum: Troubleshooting and Bug Reports
Topic: LCD changes
Replies: 0
Views: 223

LCD changes

Hi, I was tweaking my printer yesterday with one of the awesome prints from thingiverse. The way i was adjusting it was by using the LCD: The question is: Where I find the Flow rate which is dialed in at 200 on the LCD and my slicer extrusion multiplier is .94. How would i go about calculating the n...

Go to advanced search