Search found 2 matches
- Fri Jun 14, 2019 11:48 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Can't Preview G-Code
- Replies: 1
- Views: 722
- Jump to post
Can't Preview G-Code
I assume you figured this one out. Just slide the "End" slider to the right. The sliders let you show layer-by-layer or line-by-line how the printer will move, but the preview comes up with both sliders full left, which shows from the start of the print to the start of the print. Since &qu...
- Wed Jun 12, 2019 3:35 am
- Forum: Troubleshooting and Bug Reports
- Topic: LCD changes
- Replies: 0
- Views: 732
- Jump to post
LCD changes
Hi, I was tweaking my printer yesterday with one of the awesome prints from thingiverse. The way i was adjusting it was by using the LCD: The question is: Where I find the Flow rate which is dialed in at 200 on the LCD and my slicer extrusion multiplier is .94. How would i go about calculating the n...
