Search found 3 matches
- Tue Feb 28, 2023 2:58 pm
- Forum: Troubleshooting and Bug Reports
- Topic: 5.02 Cooling Fan Speed Not Updating
- Replies: 1
- Views: 513
- Jump to post
5.02 Cooling Fan Speed Not Updating
Slightly modified TronXY X5SA printer with a BTT 1.4T board and Hemera extruder. I'm trying to turn off the fan for the first few layers, to get better adhesion, so I set fan speed of zero for the first layer and then change the speed according to the filament I'm using. I've never had a problem unt...
- Sun Jul 07, 2019 3:31 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Heat settings
- Replies: 1
- Views: 1412
- Jump to post
Re: Heat settings
What printer do you have? On my Creator Pro, T0 is the right and T1 is the left extruder. You set the temperature by setpoints, with the first setpoint at layer 1. Other setpoints can be set, if desired, for different temps on different layers, but usually only the one setpoint is needed. Use the 'A...
- Sun Jul 07, 2019 3:01 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Immediate Crash After Startup -- Bad STL File
- Replies: 1
- Views: 1411
- Jump to post
Immediate Crash After Startup -- Bad STL File
I didn't see this posted anywhere so I thought I'd share: My Simplify 3d 4.1.2 continually crashed immediately after starting. It showed I had an STL file already imported, even after repeatedly uninstalling and installing the software. I tried Ccleaner on the registry, restarts, and cold starts, al...
