Simplify3D User Forum

buckker

Hi Horst Maybe I have to say, that I normally have very good printing results. Also no stringing with PETG. I have to increase the hotend temperature after changing to a full metal nozzle. So, I don't believe that my printing paremeters are that wrong. 3D jake recommends 230 to 250° for their PETG, ...

buckker

Hi Horst Many thanks for having a look at the factory file. The main issue is that the printer has a stop & go behavior while printing the outer perimeter during the mode "allow single extrusion walls". I think simplify calculate a wrong amount of material. As a result of this are the ...

buckker

I should upload the factory file earlier.... Here it is

Many thanks in advance

buckker

Is it possible to remove it from the post processing? Yes, you can remove comments from the generated G-code, and it's worth a shot. Just add the command {STRIP ";"} in " Scripts > Additional terminal commands for post processing " Let us know about the results! I tested it on m...

buckker

I got nearly the same result. After long hours of testing, I find out the "External Thin Wall Type" set to Perimeters only gives a nice print. With "Allow Single Extrusion walls" I got very ugly prints. It seems that simplify has a bug in this case. It would be very nice if someo...

buckker

Hi I'm experimenting with thin wall parts on my Sidewinder X1. Normally I would prefer using Simplify3D over Cura oder Slic3r for those parts. Now I'm facing with a strange stop and go in printing speed on my Artillery Sidewinder X1. Also the the prints are very bad. Very interersting is the fact th...

Search found 6 matches

Re: Strange printing speed with Simplify3D

Re: Strange printing speed with Simplify3D

Re: Strange printing speed with Simplify3D

Re: Strange printing speed with Simplify3D

Re: Thin Wall Single Extrusion - Excessive Extrusion

Strange printing speed with Simplify3D