Search found 10 matches

Go to advanced search

by freakaccident
Sat Feb 08, 2020 12:06 am
Forum: General Discussion and Tips
Topic: Busiest/Largest 3d Printing forum website?
Replies: 3
Views: 2821

Busiest/Largest 3d Printing forum website?

What are the best, busiest, and largest, 3d printing forums out there? I am having trouble finding them.
by freakaccident
Fri Feb 07, 2020 8:32 pm
Forum: Troubleshooting and Bug Reports
Topic: Print issue...walls of print too thin.
Replies: 1
Views: 1155

Print issue...walls of print too thin.

So I printed a cube and the walls are so thin that there are holes in them. I have attached a pic. What could be causing this? Not enough material being extruded? Should I change the multiplier?
by freakaccident
Thu Feb 06, 2020 9:46 pm
Forum: Troubleshooting and Bug Reports
Topic: Ender 3 Pro Wipe problem hit glass bed clips
Replies: 7
Views: 1057

Re: Ender 3 Pro Wipe problem hit glass bed clips

My code draws the line on the left to avoid my clips. G92 E0 ; Reset Extruder G1 Z1.0 F3000 ; move z up little to prevent scratching of surface G1 X0.1 Y20 Z0.3 F5000.0 ; move to start-line position G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line G1 X0.4 Y200.0 Z0.3 F5000.0 ; move to side a little G...
by freakaccident
Thu Feb 06, 2020 7:13 pm
Forum: Troubleshooting and Bug Reports
Topic: Issue with nozzle dragging across print to next print spot...
Replies: 8
Views: 1348

Issue with nozzle dragging across print to next print spot...

So I am printing a first layer test and I am having issues. Near the end of the print it finishes the last few lines on the other side of the layer and as it moves over to print those lines it drags the nozzle across the already printed 1st layer. I have gone into the process settings and set the re...
by freakaccident
Thu Feb 06, 2020 3:28 pm
Forum: Troubleshooting and Bug Reports
Topic: Print via USB is ignoring my startup script...
Replies: 2
Views: 653

Re: Print via USB is ignoring my startup script...

I may have this working. I copied my starting script from Cura. I believe that in s3d you need to use [ instead of { for your commands.
by freakaccident
Thu Feb 06, 2020 2:34 pm
Forum: Troubleshooting and Bug Reports
Topic: Print via USB is ignoring my startup script...
Replies: 2
Views: 653

Print via USB is ignoring my startup script...

Basically I want to run my own startup script because I do not like that the extruder heats up before G28 and G29 run. The nozzle leaks from gravity because it sits there so long heated up. G28 and G29 run fine but the extruder still heats up before G28 and G29 even though my script doesn't specify ...

Go to advanced search