Search found 4 matches

Go to advanced search

by monikioo
Thu Feb 13, 2020 5:13 pm
Forum: Troubleshooting and Bug Reports
Topic: S3D Generating tiny line segments and causing seam issues in vase mode
Replies: 6
Views: 192

Re: S3D Generating tiny line segments and causing seam issues in vase mode

Thank you! that was VERY helpful. I was manually removing the short z segments but reducing the mesh makes total sense!!
by monikioo
Thu Feb 13, 2020 3:34 pm
Forum: Troubleshooting and Bug Reports
Topic: S3D Generating tiny line segments and causing seam issues in vase mode
Replies: 6
Views: 192

Re: S3D Generating tiny line segments and causing seam issues in vase mode

This is the problematic Z code. The line segment length goes from 1.7 to 0.005. G1 X167.657 Y241.486 Z1.797 E81.7276 G1 X169.005 Y240.426 Z1.798 E82.0502 G1 X170.376 Y239.404 Z1.800 E82.3718 G1 X170.380 Y239.400 Z1.800 E82.3728 ; layer 5, Z = 2.200 G92 E0.0000 G1 X170.384 Y239.397 Z1.800 E0.0010 F44...
by monikioo
Thu Feb 13, 2020 11:53 am
Forum: Troubleshooting and Bug Reports
Topic: S3D Generating tiny line segments and causing seam issues in vase mode
Replies: 6
Views: 192

Re: S3D Generating tiny line segments and causing seam issues in vase mode

I have a closed model, and also have Merge all outlines into a single solid model enabled. I have printed very similar geometries in the past with no issues. I am aware of the vase mode limitations. However, even though it is supposed to be a continuous strand, the gcode itself still has layers iden...
by monikioo
Wed Feb 12, 2020 5:16 pm
Forum: Troubleshooting and Bug Reports
Topic: S3D Generating tiny line segments and causing seam issues in vase mode
Replies: 6
Views: 192

S3D Generating tiny line segments and causing seam issues in vase mode

My recent prints have had this issue that when I slice the stl file, there will be a tiny little line segment leftover per layer, and this causes the printer to essentially pause and I end up getting globs along the seam. I am printing a pipe in vase mode. I have not had this issue in the past with ...

Go to advanced search