Simplify3D User Forum

zzjlamb

The profile file for the MMU2S is now up to revision 15. Revision 3 in the earlier post is now out of date and doesn't work properly. There doesn't seem to be a download section on this website, however the Support people at S3D are very helpful and will send you the latest revision on request. I go...

zzjlamb

Still no updates at all for a long time, but on the other hand, my Version 4.1.2 is working perfectly on Mac OS Big Sur, and I don't have a burning need for new features. If it aint broke then don't fix it? The only concern would be that it will become abandonware, but no likelihood of that at least...

zzjlamb

Not only does the travel follow the outer perimeter, but the path seems unnecessarily complicated. I've attached a screenshot of a travel path to illustrate, and the corresponding part of the print. You can see that because the travel goes around a tight corner, the string goes outside the outline b...

zzjlamb

Further to my previous post, I was using Contour, not Waterfall as I thought. Also, I notice that it was only happening on one extruder. Both extruders had the same settings, except the right (grey) extruder had Wipe set and the left (red) did not.

zzjlamb

I'm having exactly the same issue using S3D 4.1.2. THe part prints smoothly but the ooze shield printing feels like the machine is going to disintegrate! Firmware is Sailfish. The reason is definitely the GCode which is printing lots of small lines rather than a smooth arc. It also slows down the pr...

zzjlamb

It's been a long time since the original post, but I thought it might help someone if I posted a solution. I had the same problem with the heated bed turning off after a few layers. It turns out that there is a setting in Settings on the printer called "HBP Power Save". This "feature&...

zzjlamb

I am running a Malyan M180 from a Mac and I'm having exactly the same problem. The com port defaults to /dev/cu.Blutooth-Incoming-Port. In my case it should be /dev/cu.wchusbmodem14321. It does it whether or not the printer is on and connected, and even after I've used Simplify with the correct port...

Search found 7 matches

Re: S3D Profile for MMU2 - Important! Check S3D Support for the latest version

Re: OK, Time to Start Yet Another "Where is Version 5? " Thread

Re: Improvement to "Avoid crossing outline for travel movements"

Re: Harsh vibration on ooze shield but not part

Re: Harsh vibration on ooze shield but not part

Re: Malyan M180 temperature switched off

Re: Defaults to the wrong port