Search found 2 matches
- Thu May 07, 2020 9:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: void where models intersect
- Replies: 0
- Views: 1848
- Jump to post
void where models intersect
I sliced and printed a model of flying elephant. Apparently the model is really composed of 3 separate pieces that intersect but are not visible. When sliced and printed the model looked normal at first however after trimming the supports it became obvious that all areas where the wing models inters...
- Thu May 07, 2020 9:24 am
- Forum: Troubleshooting and Bug Reports
- Topic: crazy Preview layer height
- Replies: 1
- Views: 1436
- Jump to post
crazy Preview layer height
I'm getting some really crazy MAX layer heights in the preview mode on the slider. 10's of thousands when the model is only a few mm's thick. I'm using v4.1.2 (Win10). Did I bump a setting somewhere?
