Simplify3D User Forum

MrServer

Thanks for the reply! Tried a change of 180 degree wit supports on the corners. Results aren't pretty. Look at the pics: https://i.imgur.com/aoA7fLY.png https://i.imgur.com/6ivTLlf.png Here is the factory file (Apologies for not adding it before... didnt know how..) https://www.dropbox.com/s/f4qvbjp...

MrServer

thanks for the response. I have a .4 nozzle and my extrusion width is set to .50. Didnt change that, but I did increase the temperature to 210, and lower the fan to 50% during the whole printing process and lower speed to 2400/mm/min. Didn't get better results. it looks the same. here is the pic: ht...

MrServer

anyone?

MrServer

Hello there! Having some issues with printer that I cannot figure out. See the image below, printed with and without support. Is that Oozing? or bad bridging? ( I am new to this, apologies in advance) https://i.imgur.com/4vRVK1i.jpg Printer: Artillery X1 v4 Nozzle Diameter: .40 mm Extrusion Multipli...

MrServer

Thanks, the issue was with the Z position being fixed. I changed that to "Optimize for start points..." under the layer setting. But now, the retraction is not smooth as I would like it to be. Some areas the blobs/zits are visible now... here is how it looks on the slicer: https://i.imgur....

MrServer

hello there! I am having some bizarre issues... take a look at this picture... this side you can see the issues... https://i.imgur.com/tsPwBRj.jpg now look at this one, which is the other side of benchy... no problems! https://i.imgur.com/B0y0NFs.jpg I cant figure out what I am missing here or what ...

Search found 6 matches

Re: Oozing? Bridging? Need help!

Re: Oozing? Bridging? Need help!

Re: Oozing? Bridging? Need help!

Oozing? Bridging? Need help!

Re: Can'r figure out this issue!!

Can'r figure out this issue!!