Simplify3D User Forum

JPCarlin

I've got an issue with printing a large part on glass bed. The material i'm printing has a very high coefficient of thermal expansion (higher than ABS), and is pretty difficult to persuade to stick to the bed as well. I've solved the bed adhesion issue at this point with some consumer products, but ...

JPCarlin

Looks like this issue has been solved After talking to Creatbot they nformed me the chamber temperature is not controllable via gcode. You set the temperature in the preheat section before starting the print and the temperature persists through the print. The printing display on this printer leaves ...

JPCarlin

After contacting creatbot they let me know that they have no way of controlling the chamber temperature via Gcode It looks like before you start a print you just set your chamber temperature in the preheat settings and that temperature persists through the print The print display on the printer cert...

JPCarlin

Hi all, I've recently purchased a Creatbot F430 for my office to be able to print some engineering polymers, namely pvdf if our case. The specs on the filament don't call out any chamber temperature needed to be able to print it, but I figure a consistent air temperature around the part would give i...

Search found 4 matches

G-Code to prevent auto shut off

Re: Chamber temperature control for Creatbot F430

Re: Chamber temperature control for Creatbot F430

Chamber temperature control for Creatbot F430