Search found 3 matches
- Wed Mar 24, 2021 12:31 pm
- Forum: General Discussion and Tips
- Topic: BCN3D Sigma Printer gaps in bottom layers?
- Replies: 0
- Views: 2271
- Jump to post
BCN3D Sigma Printer gaps in bottom layers?
Hi Everyone, I've been trying to debug this issue for a while now and cannot seem to figure it out. My first layer has gaps, which leads to poor structural integrity and adhesion between the first and second layers. See picture https://imgur.com/rXC5NDy . I have tried everything it seems to try to c...
- Thu Oct 01, 2020 6:53 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Starting script issues with XYZ DaVinci Duo 2.0 (running repetier 0.92 FW)
- Replies: 1
- Views: 1300
- Jump to post
Starting script issues with XYZ DaVinci Duo 2.0 (running repetier 0.92 FW)
Hi Everyone, I was able to hack my Davinci Duo 2.0A to get rid of the terrible firmware that XYZ put on it and put repetier firmware on it. No I have to basically re-learn my printing settings, but overall I like it much better! I am trying to run the starting script where it places the extruders in...
- Tue Sep 22, 2020 7:50 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Trying to captivate some hardware with XYZ DaVinci Duo 2.0 but running into crashing issues
- Replies: 1
- Views: 841
- Jump to post
Trying to captivate some hardware with XYZ DaVinci Duo 2.0 but running into crashing issues
Hey Everyone, Like the title suggests I am trying to captivate some hardware (nuts) in my print. I could not get the pause script to work so instead I did two prints. The first print, I printed up to layer X and stopped. I inserted the hardware and then ran another print where is started the print a...
