Search found 4 matches
- Tue Jun 22, 2021 4:02 am
- Forum: Troubleshooting and Bug Reports
- Topic: Support "Extra inflation" prints in air
- Replies: 1
- Views: 1542
- Jump to post
Support "Extra inflation" prints in air
Hello, when I use "extra inflation distance" > 0 the support structure is extended but there is nothing to support the inflated part. Support.png If I recall it right this was different in an earlier release, right? I think some time ago these inflated supports were extended down to the bu...
- Fri Feb 05, 2021 2:52 am
- Forum: Troubleshooting and Bug Reports
- Topic: Crash due to special characters
- Replies: 1
- Views: 1061
- Jump to post
Crash due to special characters
Hello, I have faced this problem several times: When I have used any models with special characters in their filenames (I live in Germany, so many words have "Umlaut" like ä, ö, ü), then on next startup I get an error message "Failed to parse XML file" and all settings are reset ...
- Thu Dec 03, 2020 6:33 pm
- Forum: Feature Requests
- Topic: Brim inside the object
- Replies: 14
- Views: 19831
- Jump to post
Re: Brim inside the object
+1 Especially when filling the entire X/Y build area, so there is no room for a brim on the outside. Then it would be good to have the brim on the inside. A drop-down menu to select where to place (inside, outside, both) would be good. The question is how to deal with non-closed outlines which do no...
- Thu Dec 03, 2020 4:38 pm
- Forum: Feature Requests
- Topic: Support 45 degree angle
- Replies: 0
- Views: 1523
- Jump to post
Support 45 degree angle
Hi, for me it would be great if support geometry could be calculated in a way so it uses reachable areas below which are not overlapping. In particular angles up to something like 45 degrees can be safely printed without support or actual bridging. Sometimes i do have prints where just a little bit ...
