Search found 5 matches
- Thu Dec 17, 2020 4:36 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Help
- Replies: 3
- Views: 1634
- Jump to post
Re: Help
Here is my most recent attempt at printing a bed leveling square. I am going to replace my bltouch just to be sure.
- Thu Dec 17, 2020 11:26 am
- Forum: Troubleshooting and Bug Reports
- Topic: Help
- Replies: 3
- Views: 1634
- Jump to post
Re: Help
Sorry for the late reply, I will post the factory file later today for you. I can't get the hot end to print based on my z offsets it always goes to Z0 instead of Z0 -2.30 offset. But when I send G1 F60 Z0 through my octoprint console it goes where it should.
- Sat Dec 05, 2020 9:36 am
- Forum: Feature Requests
- Topic: [ADDED] Ironing
- Replies: 123
- Views: 354312
- Jump to post
Re: Ironing
+1 for this.
My top layer from a free slicer looks substantially better than my top layer from S3D. Not short selling S3D I use it over Cura for all the other amazing features. Just want to be able to finally delete Cura
My top layer from a free slicer looks substantially better than my top layer from S3D. Not short selling S3D I use it over Cura for all the other amazing features. Just want to be able to finally delete Cura
- Sat Dec 05, 2020 9:22 am
- Forum: Feature Requests
- Topic: Is there a 'ruler' available?
- Replies: 13
- Views: 17572
- Jump to post
Re: Is there a 'ruler' available?
This is what I was coming here to request.
A point to point measurement tool like what I use in Fusion 360 would be amazing for resizing existing parts and checking specific points.
A point to point measurement tool like what I use in Fusion 360 would be amazing for resizing existing parts and checking specific points.
- Fri Dec 04, 2020 10:56 am
- Forum: Troubleshooting and Bug Reports
- Topic: Help
- Replies: 3
- Views: 1634
- Jump to post
Help
So I haven't changed any settings and this randomly started. No clue how to fix it im about to wipe everything.
