Search found 6 matches

Go to advanced search

by sstarek
Tue Jun 08, 2021 8:42 am
Forum: Troubleshooting and Bug Reports
Topic: Simplify freezing
Replies: 5
Views: 515

Re: Simplify freezing

To expand on the last answer, issues that have caused freezing: Bad stl file........try different stls, and run these two through a repair utility if you can slice other stls Non-supported characters in the stl or profile names......rename using basic alphabet. Corruption in profile........delete p...
by sstarek
Tue Jun 08, 2021 8:37 am
Forum: Troubleshooting and Bug Reports
Topic: Simplify freezing
Replies: 5
Views: 515

Re: Simplify freezing

I have not had this problem, and I run W10 64 bit as well. I seem to recall other posts that mentioned issues with their graphics systems. You might check to see if your graphics card is running the latest drivers. You can also search the forum for any posts from users with the same graphics hardwa...
by sstarek
Mon Jun 07, 2021 10:34 am
Forum: Troubleshooting and Bug Reports
Topic: Simplify freezing
Replies: 5
Views: 515

Re: Simplify freezing

I'm using windows 10 - 64 bits.
by sstarek
Thu Jun 03, 2021 12:54 pm
Forum: Troubleshooting and Bug Reports
Topic: Variable Settings Wizard
Replies: 2
Views: 389

Re: Variable Settings Wizard

Thanks, I changed profiles and it gone. But thanks for your help!
by sstarek
Wed Jun 02, 2021 2:31 pm
Forum: Troubleshooting and Bug Reports
Topic: Simplify freezing
Replies: 5
Views: 515

Simplify freezing

Hello, My Simplify v.4.1.2 is freezing when I trie to "Prepare to Print!" It is stopping at the bar and does not load. I have to close the program and open it several times until it slices and sometimes it crashes when I'm going to save the Gcode I'm forced to close and open it again. He keeps think...
by sstarek
Mon May 31, 2021 12:59 pm
Forum: Troubleshooting and Bug Reports
Topic: Variable Settings Wizard
Replies: 2
Views: 389

Variable Settings Wizard

Hello, After use the Variable Settings Wizard I can't use normal process, I tried to delete all the created processes and created a new normal one and even then the piece is getting cut. I attached a video demonstrating what is happening. I've tried uninstalling and installing and nothing, it's stil...

Go to advanced search