I need this feature as well. USB connection seems to always intermittently die for no reason.

There seems to be this in options but I have been unable to get it to see the printer

OK so this seems to work.


Retract and vertical lift only happens when moving more than 3mm from point to point.

The 3mm move may want increasing , depending on the size of your object,

Same here. It needs to Z-lift while not extruding. Traveling only.

While there is a global flow rate (extrusion multiplier) I think it would be useful to have a percentage box for the first layer and also infill. While there are settings the first layer to set width and height, or better bed adhesion, it would be useful to have a flowrate override box there to incr...

I think I figured out this problem in case it helps someone else..

Seems the bed is simply too close to the head. Its pushing down the filament too much and spreading it out more, so when the fill is done, there is simply less room, so it "piles up" more.

For example this is a basic hollow square.. 1.JPG Prince absolutely perfectly other than the " zigzag infill" which seems to over extrude. I can of course manually set infill four layers which are not "solid". For example this is just 10% infill. 2.JPG But I do not seem to see or...

In the machine control panel, I can change the speed with the large knobs. I think this is a very good feature. But it would be good if there was other similar features could be changed on the fly. For example, flowrate tweaking. Currently I have to print out a large square for calibrating my printe...

Firstly while I can increase the size of the pillars, this causes problems elsewhere.. Auto generating support is of course very useful, but this is a "global" thing. For example the part below.. 1.JPG All automatic supports were fine, but I did not actually want internal ones. The only wa...