Search found 7 matches
- Thu Feb 24, 2022 10:19 pm
- Forum: General Discussion and Tips
- Topic: Vase Mode toolpaths
- Replies: 3
- Views: 6561
- Jump to post
Vase Mode toolpaths
So I'm printing the Eclipson Model A Fus1 part. This is a thin walled design, 0.4mm or 0.8mm thick walls. Regular slicing wasn't producing the best of results, probably mechanical and tuning issues are adding to the difficulties. I turned on vase mode and got much better results but I was surprised ...
- Fri Nov 05, 2021 10:23 am
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
- Fri Nov 05, 2021 9:58 am
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
Re: Order of Printing Multiple Parts
Read this article, particularly the third part. https://www.simplify3d.com/support/articles/multi-part-printing/ I did read through that but that would also require spreading my parts out making me do multiple runs to make enough for my product. At that point I could just do one at a time and they ...
- Fri Nov 05, 2021 9:38 am
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
Re: Order of Printing Multiple Parts
remove the center model so you have a circle I'll take a look at that possibility but I need 9 of these for each finished unit I am making with them. To lose one would mean I have to make multiple runs to complete my product. These are battery "positioners" for a special type battery I am...
- Fri Nov 05, 2021 9:35 am
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
Re: Order of Printing Multiple Parts
But it only gets so far through the layers and then it starts to jump around again. It starting jumping around at 1.5mm height. There's two processes in your screenshot - any chance you're slicing using both and did only change the setting for one of them? No, I changed all the setting for the proc...
- Thu Nov 04, 2021 10:14 am
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
Re: Order of Printing Multiple Parts
Thank you for the suggestion but unfortunately that does not work. Still a jumbled order of printing. Strangely though, after I unchecked the box for that option and then resliced the file it appears to be doing a better job of going from one part to the one immediately next to it and upon layer cha...
- Tue Nov 02, 2021 12:29 pm
- Forum: General Discussion and Tips
- Topic: Order of Printing Multiple Parts
- Replies: 11
- Views: 11771
- Jump to post
Order of Printing Multiple Parts
Is there no control over the order that parts are printed of multiple parts? I have a part that I can fit 9 of on my print bed. Back left is #1, going right is #2, #3, coming forward one row to the middle row is #4, going left is #5, #6, coming forward to the front row is #7, going right is #8, #9 a...
