Search found 2 matches
- Wed Jan 12, 2022 10:39 pm
- Forum: General Discussion and Tips
- Topic: need profile for creality cr-10 v3
- Replies: 1
- Views: 4790
- Jump to post
Re: need profile for creality cr-10 v3
I have an ender 5 and I think I could help if you don't have it working yet. It should not matter about direct drive as you should be still verifying that your retract is correct for you set up.. Bowden tube.. bigger number... Direct Drive .. smaller number. Not much else is different in the profile.
- Mon Jan 03, 2022 6:42 pm
- Forum: General Discussion and Tips
- Topic: Am I missing something? No improvement after 60 days
- Replies: 0
- Views: 4557
- Jump to post
Am I missing something? No improvement after 60 days
I am printing on Creality Ender 5 plus with a Mosquito magnum PLA 0.2 and prints are good and consistent. My issue is I cannot get better results out of Simplify3d then Cura. I feel like I was under the impression that this program would take me to the next level. It costed a lot and used by many ma...
