Search found 5 matches

Go to advanced search

by pyrphia
Wed Jun 21, 2023 8:04 pm
Forum: Feature Requests
Topic: Dynamic Extrusion Widths for Perimeters
Replies: 1
Views: 369
 
Jump to post

Dynamic Extrusion Widths for Perimeters

It would be nice to have dynamic extrusion widths for not only single extrusions, but for perimeters, as well. You can see in the attached picture, there are gaps on the outside of the loops between perimeters, while in the middle, the overlap is more than necessary.
by pyrphia
Wed Mar 29, 2023 12:26 pm
Forum: Troubleshooting and Bug Reports
Topic: Variable Extrusion Width not working?
Replies: 2
Views: 470
 
Jump to post

Re: Variable Extrusion Width not working?

I think you are right...and I think it is a limitation in the program. Prusa is able to do it right. It can vary the extrusion width of the outer perimeters so it doesn't even need to fill in any gaps.
by pyrphia
Fri Mar 24, 2023 6:49 pm
Forum: Troubleshooting and Bug Reports
Topic: Variable Extrusion Width not working?
Replies: 2
Views: 470
 
Jump to post

Variable Extrusion Width not working?

I have started to use V5.0, and it seems that the variable extrusion width is not working, even though I have the min set to 50% and max at 200%. I have attached a screenshot showing large gaps between walls and the line width apparently the same, and also the factory file.
SS.png
RaT.factory
(51.06 KiB) Downloaded 55 times
by pyrphia
Tue Mar 21, 2023 10:31 pm
Forum: General Discussion and Tips
Topic: Lines every 4mm
Replies: 0
Views: 3662
 
Jump to post

Lines every 4mm

I am starting to print multiple pieces through sequential printing and have set it up to print each piece 4mm at a time. However, I notice slight bulging lines on the outer surfaces of the pieces every 4mm because of this. Not extreme, but noticeable. If anyone has any thoughts on how to reduce or e...
by pyrphia
Fri Apr 01, 2022 9:41 pm
Forum: General Discussion and Tips
Topic: Where the heck did my processes go???
Replies: 4
Views: 1307
 
Jump to post

Where the heck did my processes go???

Hello everyone. I recently bought this software a few days ago because I know there are so many features to it that other slicers do not appear to have. However, I have been going crazy with this dysfunctional interface between profiles and processes. I have two printers: a Tevo Tornado and an Ender...

Go to advanced search