Search found 3 matches
- Sat Jan 07, 2023 9:12 am
- Forum: Troubleshooting and Bug Reports
- Topic: V5 issue on Mac M1
- Replies: 10
- Views: 3326
- Jump to post
Re: V5 issue on Mac M1
TLDR; v4 is unusable on the Mac M1, switched to PrusaSlicer. S3D has ruined its reputation. I doubt we'll see an M1-optimized version anytime soon. The V5 rendering engine should be quite a bit faster than V4. Did you ever use V4 in the past on this same computer, or are you just using V5 now for t...
- Fri May 20, 2022 9:40 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Help me get this printer dialed in.
- Replies: 1
- Views: 633
- Jump to post
Re: Help me get this printer dialed in.
Ok, so I just tried the aligned seam starting point and that made a WORLD of difference! Why did the optimized starting point affect the print quality the way it does? What setting(s) do I need to tune to make it less noticeable? The Aligned Seam is on the left and the Optimized Seam is on the right...
- Fri May 20, 2022 4:45 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Help me get this printer dialed in.
- Replies: 1
- Views: 633
- Jump to post
Help me get this printer dialed in.
I’m having a print quality issue that I’m having trouble describing and fixing. Basically, my prints have these bands that run horizontally through the print. Some layers will have a little bump before going into the corners. I’ve tried reducing the print speed to 20 mm/s, increased/decreased the ex...
