Search found 7 matches
- Sat Jul 23, 2022 6:22 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Linux install .run problem
- Replies: 2
- Views: 1612
- Jump to post
Re: Linux install .run problem
I should also state that this is on an NVIDIA Jetson Nano (which is ARM based) -- minimum requirements state an Intel processor, but is there a strict Intel limitation?
- Sat Jul 23, 2022 6:15 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Linux install .run problem
- Replies: 2
- Views: 1612
- Jump to post
Linux install .run problem
Have downloaded and unzipped the 64-bit Linux install onto a 18.04 distribution. When I run the .run file (after unzipping in the download directory), I get the following error: sudo ./Simplify3D-4.1.2-linux-x64-installer.run ./Simplify3D-4.1.2-linux-x64-installer.run: 1: ./Simplify3D-4.1.2-linux-x6...
- Thu Jul 14, 2022 9:58 am
- Forum: Feature Requests
- Topic: [ADDED] Dremel 3D45
- Replies: 4
- Views: 3603
- Jump to post
Re: Dremel #D45
As far as I am aware Dremel still does not supply or offer drivers for the 3D45 so it is not able to communicate via USB. I would be happy to send a request to our development team for network printing with this printer though! --> I reached out to Dremel -- they have licensed off their 3D printer ...
- Sun Jul 10, 2022 11:23 am
- Forum: Feature Requests
- Topic: [ADDED] Network Printing
- Replies: 33
- Views: 60482
- Jump to post
Re: Network Printing
Add me also to the list for network printing to 3D45.
Sneakernet is so 1999
Sneakernet is so 1999
- Sun Jul 10, 2022 10:00 am
- Forum: Feature Requests
- Topic: [ADDED] Dremel 3D45
- Replies: 4
- Views: 3603
- Jump to post
Re: Dremel 3D45
That would great and I will be happy to help validate it/test it for you
- Sat Jul 09, 2022 12:55 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Opinions on first layer
- Replies: 4
- Views: 2121
- Jump to post
Re: Opinions on first layer
Resolved? You might try printing even lower speed on the first layer?
- Fri Jun 10, 2022 12:37 pm
- Forum: Feature Requests
- Topic: [ADDED] Dremel 3D45
- Replies: 4
- Views: 3603
- Jump to post
[ADDED] Dremel 3D45
Dremel states that Simplify3d is a supporting Software package, and Simplyfi3D states that Dremel 3D45 is a 'supported' printer, yet is this only through thumb drive transfer? None of USB, wired Ethernet or Wi-Fi paths seem to be supported. I saw another post from 20221 about USB driver not being 'b...
