Simplify3D User Forum

KarlW1000

Looks like a bug in the software. I tried a lot of different settings so the results were somewhat close to original. After slicing, the file looks good in simplify3d but I exported the Gcode file and imported it into Repetier Host and you can clearly see that it will not print correctly. It looks j...

KarlW1000

Same thing happened to me. The following is a note I kept that worked. If model disappears after hitting prepare to print Turn on wifi and/or make sure you have internet access on your simplify3d machine. Exit and restart simplify3d It will probably ask you to login. Login Should be good to go. Make...

KarlW1000

Version 5, On the Accessory Controls in the Machine Control Panel, does anyone know if there's way to set defaults for the bed and Primary extruder temperatures?
Thanks
Karl

KarlW1000

Bought it in April of 2014.
According to this site:

"https://makergear.zendesk.com/hc/en-us/ ... D-Printers"

the revision is B.1

KarlW1000

Manually sending M112 from either version does nothing. Re-downloaded the most current Firmware for my machine from Makergear and installed Same results, M112 does nothing. Output when connecting to the printer: Attempting connection at \\.\COM3... READ: start READ: echo:Marlin: 1.0.0 RC2 for MakerG...

KarlW1000

Jason, Just to be clear, when I say stopped below, I mean the motors are disabled, bed heater is turned off, extrude heater is turned off, program execution is halted, everything is reset as if the printer was just connected to the computer. I am running Simplify3D Versions 4.1.2 and 5.1.2 on the sa...

KarlW1000

Jason, Any word from the programmers about getting the E-Stop to work as in version 4.1.2? Pressing the E-stop button or sending the M112 command will NOT stop the machine. The movement will stop after about 8 more lines of code are executed but the bed heater and motors are never shut off. Currentl...

KarlW1000

Jason,
Since the OP did not reply, do you know if anything has been found about this. I can't imagine the OP and myself are the only 2 that have experienced this behavior. It would be nice if the E-Stop worked as in version 4 and stopped the machine immediately.
Karl

KarlW1000

Jason, I have realized that getting the check boxes back that we had in version 4 will not happen. After reading all the different comments about the boxes, we will probably not see anything until the next paid version comes out because the check boxes will act slightly different and classified as a...

KarlW1000

Always having to select which printer to use is unnecessary when you only have one printer. A checkbox or some way to stop asking would be a welcome addition.

Search found 18 matches

Re: Il y a des manques / some missing information

Re: Prepare to print

Accessory Controls

Re: E-Stop and Pause Not Working

Re: E-Stop and Pause Not Working

Re: E-Stop and Pause Not Working

Re: E-Stop and Pause Not Working

Re: E-Stop and Pause Not Working

Version 6 ??

Re: Begin printing does not remember the selected machine