Search found 3 matches
- Thu Mar 09, 2023 10:20 am
- Forum: Troubleshooting and Bug Reports
- Topic: Different starting z point from Cura and S3D?
- Replies: 2
- Views: 393
- Jump to post
Re: Different starting z point from Cura and S3D?
Thanks, but it is sound strange to me because I'm only change from Cura to S3D with same model, all the other settings shall be the same... Actually I'm printing at 0.1mm layer height, I've did a check about the first layer height, in Cura I've this setting: image1.jpg so I've use same in S3D as bel...
- Wed Mar 08, 2023 12:44 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Different starting z point from Cura and S3D?
- Replies: 2
- Views: 393
- Jump to post
Different starting z point from Cura and S3D?
Dear all, I'm try to use S3D on my Longer LK5 Pro, loaded the S3D default printer profile and start a printing. The first issue is about the Z position, with S3D the head go to touch the printing plate, but this is not the case with Cura where the distance is ok. What parameter I've to look in order...
- Wed Mar 08, 2023 3:13 am
- Forum: General Discussion and Tips
- Topic: Support & first layer direction the same
- Replies: 2
- Views: 1302
- Jump to post
Re: Support & first layer direction the same
Dear All,
I'm using Simplify3D version 5.0.2 I'm unable to see the inf you have into the Support panel also after activating the Advanced view, here below my screen looks like:
could you please let me know how to see or where are located these options?
Thank you!
I'm using Simplify3D version 5.0.2 I'm unable to see the inf you have into the Support panel also after activating the Advanced view, here below my screen looks like:
Thank you!
