Search found 4 matches
- Fri Mar 10, 2023 10:54 am
- Forum: General Discussion and Tips
- Topic: Anyone using 5.0.2 with Bambu P1P
- Replies: 5
- Views: 4269
- Jump to post
Re: Anyone using 5.0.2 with Bambu P1P
I think without the bambu cloud it will be difficult to print files directly. Easier solution will be to upload the programs to the SD card via FTP over the wifi network. As I currently understand it, the data is uploaded to the cloud and the printer downloads it from there. Which technically makes ...
- Fri Mar 10, 2023 9:04 am
- Forum: General Discussion and Tips
- Topic: Anyone using 5.0.2 with Bambu P1P
- Replies: 5
- Views: 4269
- Jump to post
Re: Anyone using 5.0.2 with Bambu P1P
Hello, I am using S3D 5.0.2 with the P1P. I also transfer the programs with the SD card. I have tried several times to establish a connection, unfortunately without success. I am trying to establish a connection to the SD card. According to the internet it should work like this: ftp://"WLAN IP ...
- Thu Mar 09, 2023 11:15 am
- Forum: General Discussion and Tips
- Topic: "First layer" on already printed surface, poor adhesion
- Replies: 2
- Views: 591
- Jump to post
Re: "First layer" on already printed surface, poor adhesion
Hello,
you are my hero.
That was exactly the solution.
Thank you very much!
greetings
Steffen
you are my hero.
That was exactly the solution.
Thank you very much!
greetings
Steffen
- Wed Mar 08, 2023 11:50 am
- Forum: General Discussion and Tips
- Topic: "First layer" on already printed surface, poor adhesion
- Replies: 2
- Views: 591
- Jump to post
"First layer" on already printed surface, poor adhesion
Hello all, I am new here, please excuse my bad English. I write with a translator. I have a problem with one part. I want to print a "bar" on a printed surface. (Image Layer_0) Unfortunately, the first layer of this bar is printed in strange long lines instead of filling the layer properly...
