Search found 1 match
- Wed May 17, 2023 10:31 am
- Forum: Troubleshooting and Bug Reports
- Topic: Support Base Layer Pulls my Printer out of Duplication Mode
- Replies: 0
- Views: 4752
- Jump to post
Support Base Layer Pulls my Printer out of Duplication Mode
Duplication mode works perfectly well on my Makergear M3; however, whenever I add a value above 0, the Code stops my printer from printing in duplication mode. The T0 nozzle stays where it is, the T1 centers to the bed (runs into the T0 nozzle), strips itself on the belt and then starts printing bet...
