Simplify3D User Forum

taylbf01

Jason,

Is there a way to get S3D to output the M106 with a T0 or T1 tool code instead of P0 or P1? I think this is my last major hurdle in getting it to work how I think it should work. I do not want to have to modify the gcode file every time in order to get it to work.

taylbf01

Much work was put into getting closer to a result that will work. I can control the right fan correctly by removing the M107 startup command. The left fan is still a work in progress. I've been corresponding with flashforge and they sent me a file that that turned on both fans successfully. I looked...

taylbf01

So I figured some things out but it's still not working correctly. The fan was working after the first layer. This is because the first layer fan was being turned off because the M106 command was a few lines in front of the M107 command. Inhad to delete the M107 from the starting script. So if I pri...

taylbf01

I set it too 100% first layer and 75% second layer.
It ran at 0% first layer, and 75% second layer

taylbf01

Updated to 5.1.2.
Set my fan to 50% first layer and 100% second.
Fan was not on the first layer but turned on the second layer.

taylbf01

I'm new to dual extruders so I'm not sure if it's something I'm doing or if it's a legit problem. When I try to run my creator 3 pro, the part cooling fans aren't controlled by the gcode generated. I set one to 20% layer 1, 50% layer 2 , and 100% layer 3. The other I added and set to 3% layer 1 and ...

Search found 6 matches

Re: 5.1.1 Creator 3 Pro can't control cooling fans

Re: 5.1.1 Creator 3 Pro can't control cooling fans

Re: 5.1.1 Creator 3 Pro can't control cooling fans

Re: 5.1.1 Creator 3 Pro can't control cooling fans

Re: 5.1.1 Creator 3 Pro can't control cooling fans

5.1.1 Creator 3 Pro can't control cooling fans