Search found 4 matches
- Wed Jan 31, 2024 4:14 pm
- Forum: Troubleshooting and Bug Reports
- Topic: ooze & Accessory Controls
- Replies: 2
- Views: 1749
- Jump to post
Re: ooze & Accessory Controls
ok i will give that a go, try setting the temp hi and then extrude several times
- Tue Jan 30, 2024 10:15 am
- Forum: Troubleshooting and Bug Reports
- Topic: ooze & Accessory Controls
- Replies: 2
- Views: 1749
- Jump to post
ooze & Accessory Controls
Hi, printer makerbot method x- using the Machine Control Panel in simplify3d i can adjust the temperature of the Active Toolhead i want to dial in, i see the temperature go to the setpoint in the Temperature Pot in the machine control panel i can also see the extruder reach the set temperature on th...
- Thu Sep 21, 2023 1:19 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Messy print using s3d and method X
- Replies: 2
- Views: 730
- Jump to post
Re: Messy print using s3d and method X
Thanks for the support info, I'm going through a massive drying cycle to see how that helps. The room Rh is 70%
As you can tell I'm a newbie
Regards
Carl
As you can tell I'm a newbie
Regards
Carl
- Tue Sep 19, 2023 4:39 am
- Forum: Troubleshooting and Bug Reports
- Topic: Messy print using s3d and method X
- Replies: 2
- Views: 730
- Jump to post
Messy print using s3d and method X
i printed this using a raft with an ooze shield using makerbot nylon 12 carbon fiber (temp 250) and makerbot PVA (temp 215) chamber temp 75
It looks pretty messy straight from the build plate, what would be your recommended setting changes?
regards
carl
It looks pretty messy straight from the build plate, what would be your recommended setting changes?
regards
carl
