Simplify3D User Forum

dsharp

What's the difference between the two settings? Currently I have my M2 setup such that 0,0 is in the middle of the center of the bed. Homing the printer results in the printhead being located at -100, -125. Currently I have an Origin Offset defined at x=100, y=125. Everything prints just fine, howev...

dsharp

I've designed a dual extruder that has only a single hot-end. This eliminates the problem of getting the offset set correctly. However since both filaments go into the same hot end, the tool change g-code needs to retract the old filament to make room for the new filament. The problem I'm having is ...

dsharp

Never mind, I just updated to the latest version and there's now an offset on the GCode tab.

dsharp

My firmware is configured so that 0,0 is the center of the bed. I can't figure out how to configure Creator to match this reality.

Adding a G92 X0 Y0 to the start gcode doesn't help because the current version of Marlin prevents moves beyond X102.5 which is now the middle of the bed.

Thanks,
Dave

dsharp

Any chance support can be added for baud rates higher than 115200? Perhaps the ability to have it settable via a text field rather than a dropdown?

Search found 5 matches

Origin Offset vs. Global G-Code Offsets

Alternative tool change sequence

Re: How do I set the origin to be the center?

How do I set the origin to be the center?

250000 bps