"time estimate"

The estimate in the machine control panel uses the actual progress of the machine for the estimate. ... Once the print is say 10% finished, the estimate should be very accurate. Did you time how long the print actually ended up taking? What % was it at when is suggested 110 minutes?

langweiler

... results are promising. However, I noticed that the displayed remaining time in the machine control panel is completely off. The Creator 3 does a ... the printer predicts a printing time of 59 minutes. The Simplify3D estimate is 110 min, which is way too much. How can I adjust/correct estimation? ...

The Machine Control Panel estimate is based on the elapsed time for the actual print. In your case, it took 27 minutes to make it to 11%, so it's reasonable to guess ...

rsworden59

... same issues you listed: - E-Stop button doesn't work. - No running estimate of time remaining or % done for currently running print. - No notification of total execution ...

cote

Hi. Simplify3D V5 changed the comment from "Built time" to "Build Time" (note the capital T). In the case of Klipper firmware, it is enough to mess things up when it comes to parsing the slicer estimate.

regnaDkciN

... input boxes up/down arrows don't repeat with long press. - No running estimate of time remaining or % done for currently running print. - No notification of total execution ...

zemlin

... file - one in V4.1.2, the other in V5 Not sure what's up with the build time estimate. What prompted me to look at the footer was a file I'm running on a Duet2Wifi-based ...

RandallOfLegend

Every slicer I have used is massively incorrect for times. You need to account for the acceleration parameters to get a better quality estimate. There was a couple of G-Code parsers that worked pretty well online. But Sadly seem to be defunct. I have been tempted to write my own over the ...

gwhite

... get a more accurate result, but it's usually not necessary. Most of the time you use this feature so the "seam" is parked at a corner where ... mm increments. Unless you need an absolutely precise location, you can estimate the coordinates of the appropriate corner closely enough from ...

teamcarlisle

... In fact, the introduction of other moderators has afforded me more time to help out with other important projects within Simplify3D. What I ... for your largest and most complex prints on day one. We had originally estimated that Version 5.0 would be completed by the end of 2019, but we ...

Search found 147 matches: "time estimate"

Re: Remaining print time on Flashforge Creator 3 is incorrect

Remaining print time on Flashforge Creator 3 is incorrect

Re: Estimated printing time bug

Re: Several V5 issues, some major

Re: Print time remaining

Several V5 issues, some major

; end of end.gcode doesn't report filament length to Duet Web Control

Re: time differences between slicers

Re: "Choose Start Point Closest to Specific Location" HOW?

Re: Why has Simplify3D been abandoned ?