Search found 35 matches

Go to advanced search

by Clayton
Wed Jul 24, 2013 6:40 am
Forum: Troubleshooting and Bug Reports
Topic: Holes in the top layers: Replicator 2X
Replies: 7
Views: 6803

Re: Holes in the top layers: Replicator 2X

Yup, and they were all printed using the stock MakerBot 7.2 firmware. Have you tried printing with the exact profile I posted earlier? If you are using ABS you would need to modify the temperatures and extrusion multiplier like I mentioned.
by Clayton
Sun Jul 21, 2013 11:55 am
Forum: General Discussion and Tips
Topic: Mysterious Holes on Print
Replies: 6
Views: 1976

Re: Mysterious Holes on Print

Very nice! Looking good!
by Clayton
Sun Jul 21, 2013 10:56 am
Forum: Troubleshooting and Bug Reports
Topic: Holes in the top layers: Replicator 2X
Replies: 7
Views: 6803

Re: Holes in the top layers: Replicator 2X

Here's the same part from the top in ABS. Only change was using an extrusion multiplier of 1.0 and increasing the temperature to 220C. I don't see any gaps in the top surface, and if anything, it's probably a hair too closely packed. You can see some slight ripples from too much overlap between adja...
by Clayton
Sat Jul 20, 2013 3:26 pm
Forum: Troubleshooting and Bug Reports
Topic: coasting bug in Gcode
Replies: 2
Views: 1461

Re: coasting bug in Gcode

FYI - This has been fixed in version 1.1.5 that will be coming out shortly. Thanks for the report!
by Clayton
Sat Jul 20, 2013 3:13 pm
Forum: Troubleshooting and Bug Reports
Topic: Holes in the top layers: Replicator 2X
Replies: 7
Views: 6803

Re: Holes in the top layers: Replicator 2X

Hey Idefix, I happened to be near a Replicator 2, so I figured what better way to help you troubleshoot than to print this myself! I'm attaching the profile I used for the print. I started with the stock Replicator 2 profile that comes with Creator and then changed the layer height to 0.2mm to match...

Go to advanced search