Search found 15 matches

Go to advanced search

by Binni1969
Wed Apr 02, 2014 12:34 pm
Forum: Troubleshooting and Bug Reports
Topic: Major bug, x-axis leaning to the right (positive)
Replies: 102
Views: 43688

Re: Major bug, x-axis leaning to the right (positive)

Here is the gcode-file, i will post a photo later.
Shall I supply the stl or the same gcode created with cura for comparison?
by Binni1969
Wed Apr 02, 2014 7:55 am
Forum: Troubleshooting and Bug Reports
Topic: Major bug, x-axis leaning to the right (positive)
Replies: 102
Views: 43688

Re: Major bug, x-axis leaning to the right (positive)

Hi,

thanks for the Support! I tried to print slow, but this had no effect. With Cura and Slicer I printed this stl (rips of an airplane wing) even faster than my fastest Trial on simplify3D without any negative effect.
I will upload the gcode when I am back home, not sure if I saved the factory file.
by Binni1969
Tue Apr 01, 2014 2:52 pm
Forum: Troubleshooting and Bug Reports
Topic: Major bug, x-axis leaning to the right (positive)
Replies: 102
Views: 43688

Re: Major bug, x-axis leaning to the right (positive)

Hi, preview looks fine. But if it was a hardware problem then why do I get perfect prints in Cura and Slic3r with the same stl-file? And the results are repeatable. When printing easier objects like calibration cubes, etc. everything works fine. In another forum a user told about the same problems w...
by Binni1969
Tue Apr 01, 2014 12:53 am
Forum: Troubleshooting and Bug Reports
Topic: Major bug, x-axis leaning to the right (positive)
Replies: 102
Views: 43688

Major bug, x-axis leaning to the right (positive)

Hi, I ran into massive trouble. Some printed parts are leaning to the right on my leapfrog creatr, it seems that every layer is minimal shifted in x-axis +direction! So my parts have a ~88° angle in z-axis not a rectangular. The glass bed is absolutely leveled and all the screws of the pulleys are t...

Go to advanced search