Search found 208 matches

Go to advanced search

by MasterFX
Sat Jun 28, 2014 6:40 am
Forum: Troubleshooting and Bug Reports
Topic: under estimated print time / print quality
Replies: 25
Views: 10004

Re: under estimated print time / print quality

printed the donuts using your files and a key widget but having problems with the finish at the top layer =( I observed the same problem... but only when using concentric infill. I was able to prevent this problem by only using one layer of concetric infill and the other infill layers are set to re...
by MasterFX
Sat Jun 14, 2014 6:21 am
Forum: General Discussion and Tips
Topic: raft separation/ model adhesion
Replies: 15
Views: 12017

Re: raft separation/ model adhesion

I'm printing ABS with "ABS-Juice" on a glass plate. That works really well for me. Printing Temperature 230°C, bed temperature 110°C. Simply put some ABS Filament parts (or remains of a print) in some acetone in an acetone proof, lockable container. Wait some hours until everything is dissolved. Bef...
by MasterFX
Thu Jun 12, 2014 1:53 pm
Forum: Troubleshooting and Bug Reports
Topic: Terrible quality under support structure
Replies: 3
Views: 2025

Re: Terrible quality under support structure

Yep, you should reduce the spacing because the 0.3mm can cause especially on curves that the filament doesn't stick the the support material and then it choses the "shortest way" which is a straight line
by MasterFX
Thu Jun 12, 2014 1:49 pm
Forum: General Discussion and Tips
Topic: Which printer to select to setup for CTC?
Replies: 2
Views: 3673

Re: Which printer to select to setup for CTC?

You can chose either the Flashforge Dual or Makerbot Replicator 1 Dual. Works well for me
by MasterFX
Wed Jun 04, 2014 1:57 pm
Forum: Troubleshooting and Bug Reports
Topic: Saving as .x3g vs. .gcode
Replies: 2
Views: 10122

Re: Saving as .x3g vs. .gcode

Check the Process Settings under Scripts.
If you enable the Checkbox the x3g and gcode are placed in the same directory
by MasterFX
Sun Jun 01, 2014 10:57 am
Forum: General Discussion and Tips
Topic: Optimal Slicing
Replies: 1
Views: 746

Re: Optimal Slicing

What about selecting a fixed start point instead of using opmized for printing speed? Sometimes it gives better results.
by MasterFX
Sat May 31, 2014 7:28 am
Forum: General Discussion and Tips
Topic: Feature request
Replies: 17
Views: 5673

Re: Feature request

davedfx wrote: I can hear the infill break when applying pressure to surfaces.
Excaly what I observed. The Honeycomb of Makerware etc. seems to be much more stronger.
by MasterFX
Tue May 20, 2014 11:28 am
Forum: General Discussion and Tips
Topic: Feature request
Replies: 17
Views: 5673

Re: Feature request

+1 for Honeycomb

Go to advanced search