Search found 13 matches

Go to advanced search

by Max Filament
Wed Feb 06, 2019 4:21 am
Forum: Troubleshooting and Bug Reports
Topic: Support Separation from part not working as expected. Circular support generation is horrible.
Replies: 22
Views: 3556

Support Separation from part not working as expected. Circular support generation is horrible.

If I put in the Separation From Part section an value other than zero then I get a separation from part. In other words if I put in 10 in the Upper Vertical Separation Layers I will indeed get 10 layers of no support below the part that I want to support. This does indeed make cleanup very easy as t...
by Max Filament
Wed Feb 06, 2019 3:50 am
Forum: Troubleshooting and Bug Reports
Topic: 4.1 generates Gcode that starts my cooling fan before it should be on
Replies: 20
Views: 2340

Re: 4.1 generates Gcode that starts my cooling fan before it should be on

Yup I can confirm this.
Fan comes on at full speed at the start of the print. Even if layer 1 is set to 0

My work around is.
Layer 1 0
Layer 2 0
Layer 3 60

Obvious bug.

Go to advanced search