Search found 17 matches

Go to advanced search

by FlashErase
Sun Mar 06, 2016 5:03 am
Forum: Troubleshooting and Bug Reports
Topic: Issue when generating the prime pillar using 2 processes
Replies: 9
Views: 3967

Re: Issue when generating the prime pillar using 2 processe

Thanks for your hint. But how I can make sure, that the separate prime pillar is printed before the layer in the model in any case? Especially if the first tool is ready with its layer in the model I fear that then the layer for the second tool within the model will be printed immediately and the pr...
by FlashErase
Fri Mar 04, 2016 12:54 am
Forum: Feature Requests
Topic: [ADDED] Slicer behavior for thin walled sections
Replies: 116
Views: 59191

Re: Slicer behavior for thin walled sections

+1
I agree with zemlin.
by FlashErase
Thu Mar 03, 2016 1:08 pm
Forum: Troubleshooting and Bug Reports
Topic: Issue when generating the prime pillar using 2 processes
Replies: 9
Views: 3967

Issue when generating the prime pillar using 2 processes

There is an issue with the prime pillar when using multiple processes for one printjob. The goal: printing an object with ABS in tool0 and support with HIPS in tool1. I generated a single-profile-process "sample_1.factory", where the prime pillar was sliced correct with alternating tool0- and tool1-...
by FlashErase
Thu Mar 03, 2016 12:09 pm
Forum: Troubleshooting and Bug Reports
Topic: S3D generates wrong code for extruder offset for FF Dreamer
Replies: 4
Views: 868

S3D generates wrong code for extruder offset for FF Dreamer

S3D generates a wrong code for the extruder offset for the printer "FlashForge Dreamer". The generated code: M612 X<x1offs> Y<y1offs> ; Set toolhead offsets will be ignored by the printer. So no correcture of the real offset of the second extruder is possible. Only after I included the correct code ...
by FlashErase
Thu Mar 03, 2016 8:58 am
Forum: Feature Requests
Topic: Software controlled ditto printing
Replies: 3
Views: 1040

Re: Software controlled ditto printing

Hmm, OK, the amplifiers itself are mounted on sockets. So it should be possible to use
plug adapters between driver and PCB to manage the signals. I'll try it out in the next
time.
by FlashErase
Thu Mar 03, 2016 6:57 am
Forum: Feature Requests
Topic: Software controlled ditto printing
Replies: 3
Views: 1040

Re: Software controlled ditto printing

Thanks for the hint. I'll try later if it is possible to heat the second extruder even if it not been used. In the worst case I'll have to modify the start script for every g-file to include the heating command manually. Because it will not be possible to wire both extruder motors in parallel becaus...
by FlashErase
Thu Mar 03, 2016 2:31 am
Forum: Feature Requests
Topic: Software controlled ditto printing
Replies: 3
Views: 1040

Software controlled ditto printing

Unfortunately the FlashForge Dreamer does not support the useful ditto print feature. As the FlashForge support told me they are not willing to add this feature to their firmware to preserve the benefits of the more expensive FlashForge Creator. The sailfish firmware with supported ditto printing is...

Go to advanced search