Works like a charm with 4.1.1
Thank you for that!

Thats the methode to get micro steps up to 1/100 mm. What does that have to do with the above question and answer? For rough manual movement select the part, press the Ctrl-key and pick it with the mouse to move. And that is exactly what the above answer is about, just a different way to drag and d...

That is where you are wrong.
The fan runs at the speed you are set. Say 60 % e.g.
It just increases the fan speed to the higher speed (100% e.g.) if the layer time drops below the threshold.
It will NOT go below your before set 60%.

S3D runs the fan at least at the speed you set it to! There is no way I now of where the speed would be reduced. (except bridging settings) You just can set a higher speed for layers below a given time where the speed will be increased. Use the "blip fan to full speed" checkbox to kick you fan in mo...

Doble click your object and click on the cross in the upper right corner.
Then drag and drop your object or use the offset settings.

The parts name most probably is something with an Ä or Ö or such.
S3D couldn`t cope with it...

... I'm not quite sure what S3D's algorithm is, but it's definitely NOT " go to maximum cooling value if the layer print time is below the threshold" It appears to be more proportional.... ... but I need to understand the algorithm better. Also, it would be nice to have a limit in S3D that you can ...

Just check on your gcode with a text editor and search for the M106 Sxxx command to check whether the fan gets powered. If you are with 4.1.0 I recommend to try that with 4.0.1, the new release is kind of buggy... Edit: Works even in 4.1.0 If you would like to provide your factory fil we could check...

gwhite wrote: ↑

Mon Nov 26, 2018 10:38 am

The pin section takes about 7 seconds to print a layer, and I had the "Increase fan speed for layers below" set to 5 seconds and 60% cooling.

Since the layer time is more than your 5sec threshold it does not kick in...

Oh man....
This is a really old one, that the update notice does not work.
Try to get hold of 4.0.1 somwhere via P2P until 4.1.1 is released.
4.1.0. is not quite working...