Search found 14 matches

Go to advanced search

by sstephan
Wed Feb 06, 2019 9:02 am
Forum: Troubleshooting and Bug Reports
Topic: very slow file writing (4.1.1)
Replies: 6
Views: 718

very slow file writing (4.1.1)

i'm not sure if it started with 4.1.1 upgrade or maybe before . when i write to sd card it takes very long to write the file . if i write to other ssd or normal hd it writes fast as before . only to sd card the speed became very slow . i formatted the card to ntfs and then its very fast again , but ...
by sstephan
Fri Dec 07, 2018 8:53 am
Forum: Feature Requests
Topic: choosing infill layer thickness same as perimeters
Replies: 6
Views: 805

Re: choosing infill layer thickness same as perimeters

This would exponentially increase time and filament use for no practical gain. for you maybe . it depends what you print . for me it will be a gain for structural use . for example this infill has no structural use for me 1.jpg if i know i'll have a high load in the middle of the part , i prefer a ...
by sstephan
Sun Dec 02, 2018 3:44 pm
Forum: Troubleshooting and Bug Reports
Topic: usb keyboard disconnects when waking from sleep
Replies: 0
Views: 196

usb keyboard disconnects when waking from sleep

each time i leave s3d open and my computer goes to sleep , next time it wakes up , the usb keyboard wont work . need to disconnect and reconnect the usb again .
all other devices (including usb mouse) work ok .
the keyboard is logitech k120 , g9 mouse ,win7 64bit
by sstephan
Sun Dec 02, 2018 3:36 pm
Forum: Feature Requests
Topic: choosing infill layer thickness same as perimeters
Replies: 6
Views: 805

choosing infill layer thickness same as perimeters

i think that the single extrusion line infill is pointless , even with 80% infill it does not add much to parts structural properties . i wish i could choose infill width by number of layers , same as done for outer perimeters . for example this is 3 layer wide honeycomb 5.jpg i want to be able to m...

Go to advanced search