Search found 14 matches

Go to advanced search

by dnewman
Tue Feb 04, 2014 10:56 pm
Forum: Troubleshooting and Bug Reports
Topic: Printing on a Cupcake with sailfish
Replies: 6
Views: 4261
 
Jump to post

Re: Printing on a Cupcake with sailfish

I do not know what the correct steps/mm are for your bot. That profile I showed is simply the profile you seem to need based upon (1) what you wrote your electronics are, (2) what I believe RepG has for those electronics, and (3) what I see in the latest GPX sources that would seem to match.

Dan
by dnewman
Tue Feb 04, 2014 10:52 pm
Forum: General Discussion and Tips
Topic: Flashforge Creator Left extruder prints off center
Replies: 3
Views: 2649
 
Jump to post

Re: Flashforge Creator Left extruder prints off center

Truly this sounds like your toolhead offsets in the EEPROM (onboard parameters) for your bot are off. The gcode for dualstrusion assumes there is NO offset between the extruders. The full offset is handled by the firmware and the amount of that offset is set in the bot's EEPROM, at least for Makerbo...
by dnewman
Thu Jan 30, 2014 10:17 pm
Forum: Troubleshooting and Bug Reports
Topic: Printing on a Cupcake with sailfish
Replies: 6
Views: 4261
 
Jump to post

Re: Printing on a Cupcake with sailfish

I figured out the extruder flow -- it needs to be absolute extrusion distance and was defaulted to relative. I can now use Simplify3D to make a gcode file that Replicatorg and execute on the printer. I can't use the x3g file though -- not enough z axis action... This suggests that somehow GPX is us...
by dnewman
Wed Jan 22, 2014 6:11 pm
Forum: General Discussion and Tips
Topic: Flashforge with Sailfish Acceleration
Replies: 3
Views: 4996
 
Jump to post

Re: Flashforge with Sailfish Acceleration

My flashforge dual bot is shaking to pieced when printing fast. I'm on sailfish with accel on in the bot. How does the 3sd creator handle the acceleration and deceleration? Sounds like you do not have acceleration enabled on the bot. You can enable it from the LCD display under Utilities > General ...

Go to advanced search