Simplify3D User Forum

mroek

I'm not bashing S3D here, and I do not for one second regret spending the money on it. It's just that even if it is very good, there are a lot of things for them to improve, some of them so simple that it can probably be done by a developer in 15 minutes. A recent example is the request (by someone ...

mroek

For the long-time users out there, how often does S3D release a new version? The current version was released in early September (I think), so it is getting a few months old, and there are lots of improvements and features for them to work on (ref all the excellent suggestions on this forum). Many s...

mroek

That's not really very useful, given that the time estimates are so wildly inaccurate. The main reason for that, is that S3D can't properly estimate the real speed of the printer. That depends on the firmware and the firmware settings, which are unknowns to S3D.

mroek

You are correct that there is no support underneath the bridge, hence it needs to bridge... :-) However, there are two long walls (as the pictures shows), and bridging between these will work nicely, provided the bridging happens in the short direction. Lengthwise bridging is clearly illogical here....

mroek

First, let me just say that I am aware of this thread on the same subject: https://forum.simplify3d.com/viewtopic.php?f=23&t=2518 However, that thread is locked, so I can't post to it. This issue is still there, look at this: bridge1.png Simplify3D chooses the worst possible bridging direction. ...

mroek

I second this. The max volumetric flow of an extruder is more or less a constant, and having such a setting as a hard limit that cannot be exceeded will simplify things a lot, and skipped steps will be more or less a thing of the past. To get really fancy, it could also be two settings, one for sust...

mroek

Yes, you can use multiple processes in a single print, and assign them to specific layer ranges.

mroek

I guess if you put M116 (before G28) in the starting script, and also uncheck the "Wait for temperature..." for both bed and extruder under the temperature tab, you should get what you want.

Search found 148 matches

Re: Release cycle of S3D

Release cycle of S3D

Re: Timeline

Re: Bridge detection logic flaw

Bridge detection logic flaw

Re: Filament feed rate limit instead of nozzle speed limit

Re: Multi Resolution

Re: Check temp before begin build