Search found 85 matches

Go to advanced search

by jfkansas
Tue Aug 11, 2015 10:32 pm
Forum: Troubleshooting and Bug Reports
Topic: 1/2 of 3rd layer is missing if First layer is set to 100%
Replies: 3
Views: 776

1/2 of 3rd layer is missing if First layer is set to 100%

I have been noticing this for a while now and finally tracked down where it is happening. I reset to factory and changed 1 thing at a time until the problem cropped up. If the first layer is set to 100 then it happens. Any other setting then it is fine. Even 99. It will also fill in over a hole. The...
by jfkansas
Wed Jan 07, 2015 11:37 am
Forum: Troubleshooting and Bug Reports
Topic: Solid InFill
Replies: 2
Views: 877

Re: Solid InFill

45, -45, 0, 90 works quite well at 15% for infill
by jfkansas
Sun Jan 04, 2015 7:40 pm
Forum: Troubleshooting and Bug Reports
Topic: Scaling, Feature or Bug?
Replies: 3
Views: 1345

Scaling, Feature or Bug?

So I scaled an object to .95 setting and all was ok. I previewed and output a .x3g file.

Closed the program, reopened, then the scaling was 1.00 again. However the part was smaller like I scaled it previously.
by jfkansas
Thu Dec 11, 2014 6:54 pm
Forum: General Discussion and Tips
Topic: Best profile for flashforge creator pro
Replies: 3
Views: 5194

Re: Best profile for flashforge creator pro

You should be using the Replicator 1 Dual for the Creator Pro. The 2x has a different build volume.
by jfkansas
Thu Dec 11, 2014 6:51 pm
Forum: General Discussion and Tips
Topic: 2.2 Release Discussion Thread!
Replies: 42
Views: 19655

Re: 2.2 Release Discussion Thread!

When attempting to install, Avast antivirus picks up some malware and deletes the .exe installer. Any ideas?

I know some software recommends disabling AV when installing. Haven't tried that yet.

Go to advanced search