Simplify3D User Forum

mikedehaan

Since my last post, I built a new extruder with a 0.3mm nozzle. I printed one of the arms again using: Layer Height: 0.1mm Dense Support Layers: 3 Dense Infill Percentage: 100% Extra Inflation Distance: 3mm ...and the difference is amazing. The nozzle alone was significant enough, but the Dense Infi...

mikedehaan

Well, those changes definitely resulted in the best print of this I've had so far. Though no matter what, the supports are ruining whichever side they're on. I tried printing vertically to decrease the amount of support structures needed, and while the print was going well (ignoring some obvious ret...

mikedehaan

I had this problem and it was due to retraction being set too high in the start gcode. Go to the "Edit Process Settings" and the Scripts Tab. Then take a look at the starting script. Look for something like "G1 E-10" This tells the extruder to retract. Your "E" value ma...

mikedehaan

I'm very new to the 3D printing world, but I've read over most of the documentation and I can't seem to figure this out. I'm printing with a Taz 6 using eSun PLA Filament. I can't seem to get a good print on these models. I've attached my factory file and the two models in case they might help illum...

mikedehaan

You can change the temperature by layer easy enough. The retraction settings however, would have to be by mm. To adjust the temperature per layer, edit the process and go to the temperature tab. Select your extruder on the left. You should see the table to set your temperature points per layer on th...

Search found 15 matches

Re: Print Quality Issue on Smaller Print

Re: Print Quality Issue on Smaller Print

Re: mini balls in the first layer

[Solved] Print Quality Issue on Smaller Print

Re: How to print last thre layers with different process?