Search found 85 matches

Go to advanced search

by RoboDLC
Fri Apr 28, 2017 3:26 pm
Forum: Feature Requests
Topic: Screen Consolidation (Machine Control Panel)
Replies: 3
Views: 1299

Re: Screen Consolidation (Machine Control Panel)

This would be great. I would love to send gcode commands (and macros, hint hint) on the command line and have instant access to the printer jog buttons.

DLC
by RoboDLC
Fri Apr 28, 2017 11:57 am
Forum: Troubleshooting and Bug Reports
Topic: bed levelling wizard
Replies: 5
Views: 3340

Re: bed levelling wizard

You all make good points. I am new to the club and have a Folger Tech Kossel 2020 delta printer. I have set my bed up with a way to level using screws and macros on Pronterface. I wish S3D had more than three macros allotted, running macros from the communications command line would be fine. Points ...
by RoboDLC
Thu Apr 27, 2017 6:39 pm
Forum: Troubleshooting and Bug Reports
Topic: bed levelling wizard
Replies: 5
Views: 3340

Re: bed levelling wizard

Ok, so this is one year later, but this guy's problem still isn't fixed in the bed leveling wizard. And please, no more "do it some other way" answers. I have a Folger Tech Kossel 2020 delta printer that I level with macros I have on Pronterface to level my bed. I can't use Simplify3d because the wi...
by RoboDLC
Sun Apr 23, 2017 4:17 pm
Forum: General Discussion and Tips
Topic: Simplify3D never heats extruder (Custom machine)
Replies: 3
Views: 1710

Re: Simplify3D never heats extruder (Custom machine)

Seems like the firmware is based on Marlin. Do you use the right G-Code (M104) to set the target temperature? (Tools => Firmware Configuration => FFF => Set Extruder Temperature: M104 S$ T#) Thanks for the response! I found the source of this problem. I have used cura before this and its gcode did ...
by RoboDLC
Sun Apr 23, 2017 2:41 am
Forum: General Discussion and Tips
Topic: Simplify3D never heats extruder (Custom machine)
Replies: 3
Views: 1710

Simplify3D never heats extruder (Custom machine)

Hi all, I built a Folger Tech Kossel 2020 Delta Printer, which of course is not in the S3D machine list. I have had to enter several things to set my printer up, but I have also found problems. For one, the program never turns the extruder heater on in its g-code. I can do it manually, but I shouldn...

Go to advanced search