Simplify3D User Forum

tonyno

The infill is part of the print and is only related to the form of the model and bounded to the perimeters

I have not seen this to be the case. If you move a model, the perimeter shifts, but the infill shifts differently. See below.

I'd prefer to be able to control this.

tonyno

The Blobs & Zits section in the Print Quality guide covers that well. How about what seems to be voids at the end of perimeters? We can't have negative values for Coasting, which would seem to be what I need, unless I'm incorrect about this being the end of the perimeter. Pic attached. I've tune...

tonyno

Necro! I have often wanted to pick a point on a/each model versus a bed location.

tonyno

Yep, +1, but after the bigger stuff.

tonyno

to exaggerate this effect make small circles while holding left click. the model will progressively move up screen relative constantly while you are moving with left click held

Wow. Never noticed until now, but confirmed on my end!

tonyno

No attachment.

Check your Support Infill Percentage. May be too low? Also, try Dense Support.

tonyno

I'd like this...

tonyno

4.1.1 on Windows 10.

tonyno

I just use a unit-cube model that I made and scale it to 1.7mm x 38mm x 0.7mm then position it on the side.

tonyno

FYI, the way Da Vinci's work is that files are sent via USB to the printer in one shot. Once the file is sent, the computer is out of the loop.

No upload status just means a pause without knowing if all is well.

Once the file is sent, S3D returns and the printer starts doing something.

Search found 182 matches

Re: Infill offset

Voids at Ends of Perimeters

Re: start point - relative to model

Re: Dark Theme User Interface

Re: 3D movement view Bug Unwanted PAN motion mixed in with Rotate Motion

Re: Layer above support looks terrible

Re: Automatic dynamic layer heights

Re: No uploading status?

Re: How do I prime the extruder without using a skirt/brim?

Re: No uploading status?