Search found 223 matches

Go to advanced search

by billyd
Thu Feb 26, 2015 8:29 pm
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2308

Re: Under extrusions in certain areas of a print

No it's when it actually prints the part. And also in preview. No attempt is made by the slicer to fill. It just acts like it wants to do just perimeters and ignores that you requested fill.
by billyd
Thu Feb 26, 2015 12:52 am
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2308

Re: Under extrusions in certain areas of a print

Thanks I resolved the issue, it was a slightly out of level build plate. A real beginner's mistake lol. Level's been good for so long I haven't had to touch it and took it for granted. But I guess it finally got just a tiny bit low on one corner. All is well. I am talking about vertical thin walls w...
by billyd
Tue Feb 24, 2015 2:04 pm
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2308

Under extrusions in certain areas of a print

Hello, It seems like certain horizontal walls are underextruded in certain areas of a print. But always in the same spot, even if I change the location on the build plate. What would cause this? Using 2.2.2 I would say it is a filament problem, but why would it be repeatable in the same areas? I got...

Go to advanced search