Ah! I didn't know that was an option. I'm still very new to S3D. In any event, I chopped off all but the top half inch or so of my model & trimmed it down to one corner where I see a lot of issues. It's working nicely as a test vehicle. I've cranked the "coast" setting up to 1.5mm. Any higher and I ...

I've done some digging, and it looks like the magic parameter is going to be "Coast", possibly balanced with tweaks to the Restart Distance, both of which I have turned off at the moment. Does anyone have suggestions for values to start with? I've seen coast numbers for PETG anywhere from 0.2 to 1 m...

I have a MakerGear M2E, and I'm printing with HatchBox PETG. It's working pretty well, but I'm getting blobs of extra material in places. It is quite repeatable, so it's not a filament issue. I can see in the S3D preview mode exactly where they are occurring. It shows up as a small speed up in the e...

Have you read this? https://www.simplify3d.com/support/print-quality-troubleshooting/#layer-shifting-or-misalignment Yes, but I don't think it quite applies, other than that my nozzle may be whacking into the print and is getting knocked slightly out of position. I ran a test yesterday, with exactl...

I'm just getting started in 3D printing, and have a new MakerGear M2E. For my first "real" print job, I grabbed a few accessories off Thingiverse, tossed them into S3D, and fired it up. I parked the parts on the bed somewhat randomly. They are three heights, with the shortest parts in between the tw...