Search found 225 matches

Go to advanced search

by billyd
Tue Mar 03, 2015 11:02 am
Forum: General Discussion and Tips
Topic: Airwolf3d HD2X profile
Replies: 16
Views: 21663

Re: Airwolf3d HD2X profile

So general question about this printer. I just got one of these, and frankly I am thinking about returning it. It seems very slow to me, even with the advanced Simplify3d software. And the print quality isn't great. Granted I haven't had it that long to tweak the settings. And the dual nozzle printe...
by billyd
Sat Feb 28, 2015 11:21 am
Forum: General Discussion and Tips
Topic: Some geometry questions regaring S3D and MB R2
Replies: 1
Views: 646

Some geometry questions regaring S3D and MB R2

I've been using S3D for quite awhile and love it but I have always wondered why the stock setup for the MB R2 uses a slightly smaller build volume than what it is capable of. About 3-5mm in each direction are cut off in the stock config. Also why does my layer height readout on my LCD not read exact...
by billyd
Thu Feb 26, 2015 8:29 pm
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2409

Re: Under extrusions in certain areas of a print

No it's when it actually prints the part. And also in preview. No attempt is made by the slicer to fill. It just acts like it wants to do just perimeters and ignores that you requested fill.
by billyd
Thu Feb 26, 2015 12:52 am
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2409

Re: Under extrusions in certain areas of a print

Thanks I resolved the issue, it was a slightly out of level build plate. A real beginner's mistake lol. Level's been good for so long I haven't had to touch it and took it for granted. But I guess it finally got just a tiny bit low on one corner. All is well. I am talking about vertical thin walls w...
by billyd
Tue Feb 24, 2015 2:04 pm
Forum: General Discussion and Tips
Topic: Under extrusions in certain areas of a print
Replies: 6
Views: 2409

Under extrusions in certain areas of a print

Hello, It seems like certain horizontal walls are underextruded in certain areas of a print. But always in the same spot, even if I change the location on the build plate. What would cause this? Using 2.2.2 I would say it is a filament problem, but why would it be repeatable in the same areas? I got...

Go to advanced search