Ender 5 with TH3D firmware and Silent Board
by demetri90 » Sun Dec 01, 2019 10:23 am » in Troubleshooting and Bug Reports

3dlabprint F86 F8
by St0mp » Sat Nov 30, 2019 6:49 pm » in Troubleshooting and Bug Reports

New revision of a model produces banding
by yeahtuna » Sat Nov 30, 2019 3:11 am » in Troubleshooting and Bug Reports

Lines in surface
by bdaehn » Wed Nov 27, 2019 7:17 am » in Troubleshooting and Bug Reports

speed first bottom and last top layer
by Zaitek » Tue Nov 26, 2019 4:55 am » in Troubleshooting and Bug Reports

Supports are bad.
by danielmccutcheon » Thu Nov 21, 2019 10:42 pm » in Troubleshooting and Bug Reports

Switching printers problem
by billyd » Wed Nov 20, 2019 8:27 pm » in Troubleshooting and Bug Reports

FlashForge Guider IIs
by Euroeng » Wed Nov 13, 2019 1:14 pm » in Troubleshooting and Bug Reports

Printer not accepting commands?
by lolixuli » Wed Nov 13, 2019 4:47 am » in Troubleshooting and Bug Reports

Discontinuity in critical perimeter
by Rovert » Wed Nov 13, 2019 4:13 am » in Troubleshooting and Bug Reports

Bed area Raise Pro 2 Plus
by nickhulinsky » Mon Nov 11, 2019 3:06 pm » in Troubleshooting and Bug Reports

multiple process printing - start/stop printing at height in mm vs layer
by airscapes » Fri Nov 08, 2019 11:44 am » in Feature Requests

Lithophane print quality
by yaksha42 » Thu Nov 07, 2019 11:07 pm » in Troubleshooting and Bug Reports

Move Nozzle to prime tower before switching
by tphan » Thu Nov 07, 2019 3:24 pm » in Troubleshooting and Bug Reports

Printer goes to left in the middle of the print
by mroschk » Wed Nov 06, 2019 1:21 pm » in Troubleshooting and Bug Reports

Same Model Differemt Settings
by Connor_0805 » Mon Nov 04, 2019 11:24 am » in Troubleshooting and Bug Reports

oozing with raise3d
by mdedieu » Sun Nov 03, 2019 12:04 pm » in Troubleshooting and Bug Reports

20MM calibratin cube Z axis overshoot
by Xabah » Fri Nov 01, 2019 5:23 am » in Troubleshooting and Bug Reports

Infil angle value relative to perimeters
by PicoTreed » Wed Oct 30, 2019 4:47 am » in Feature Requests

Updated File Locations for S3D?
by FireNWater » Tue Oct 29, 2019 4:04 pm » in Troubleshooting and Bug Reports

Single perimeter wall with special support
by xoxu » Tue Oct 29, 2019 3:18 am » in Troubleshooting and Bug Reports

Very bad overhang behaviour
by janmaier37 » Sun Oct 20, 2019 5:24 pm » in Troubleshooting and Bug Reports

Computer not talking to printer
by jpmreno » Sun Oct 20, 2019 5:16 pm » in General Discussion and Tips

Gaps Along Thin Walls
by sykesrobin » Thu Oct 17, 2019 3:54 pm » in Troubleshooting and Bug Reports

S3D and Bibo printer via IP
by John SC » Mon Oct 14, 2019 5:09 pm » in Troubleshooting and Bug Reports