I want to vary the infill of the part horizontally rather than layer by layer.
This would be primarily used for parts that are printed with Flexible materials.
For example, I need to print something like this (attachment):
The areas in RED I would want to be at something like 100% Infill, where as the rest of the part I would only want at say 20% infill.
Right now the whole part needs to be the same Infill %. I want the arms to be able to stretch, but all the areas around the hole I need to be stiff.
I could do separate processes if I cut the model up into multiple pieces, but it would be nice if I could just select parts to vary the infill as I might not know where to adjust the infill until I've printed a few pieces.