inventabuild
Posts: 80
Joined: Sat Mar 19, 2016 12:29 pm

Please Separate Outline Overlap & Solid Infill Overlap

Mon May 14, 2018 8:37 pm

Sometimes solid infill is printing beautifully, but the Outline Overlap needs to be increased to eliminate gaps between the perimeter and the infill which, the way S3D is currently setup, also increases the solid infilll overlap. This causes excessive solid infill to be printed leading to stringing and messy prints.

There's no good reason to link an ncrease in the outline Overlap to an increase in solid infill overlap.

Please have a separate setting for both.

Return to “Feature Requests”