Hi,
I have experienced problems when printing solid layer on top of infill, especially on larger surfaces. the beginning of solid layer line does not hit the infill and it curls (upwards mostly). Then the nozzle hits the curled ends and makes mess. It is possible to avoid this happening by not blowing on the layer right on top of the infill.
My question is, is there any way to turn off printing fan for solid layers? Even better, for 1st layers after infill layer is done?
I have tried post-processing script, but it does not appear to support any variables like [fan_speed_percentage].
the fan speed via M106 is set only on the points specified in Cooling tab. it is not called before every layer.
can anybody advise please?