Infill Auto Density feature
Posted: Mon Jan 07, 2019 7:23 pm
So today I'm printing a design that has A LOT of infill. To cut down on waist I'm printing at 5% infill. This is great for 80% of the print but there are a few areas where the infill is not dense enough to support some top layers without using 7 or 9 top layers to make up for the mess that the first couple layers are.
What would really be cool is if we could set the infill to AUTO DENSITY and then set a min density of say 5%. Then when the job is sliced it can add infill density where it might be needed to reduce bridging. I think this feature would be a HUGE improvement over what we have now.
If you have any questions please feel free to ask.
Tony
What would really be cool is if we could set the infill to AUTO DENSITY and then set a min density of say 5%. Then when the job is sliced it can add infill density where it might be needed to reduce bridging. I think this feature would be a HUGE improvement over what we have now.
If you have any questions please feel free to ask.
Tony