Posts: 5
Joined: Wed Apr 25, 2018 4:28 pm

Mosaic Palette2

Fri Feb 01, 2019 12:55 am

will there any possibility for simplify3d to support the mosaic pallette 2?

Posts: 3
Joined: Sun Jun 12, 2016 7:52 pm

Re: Mosaic Palette2

Sun Feb 03, 2019 8:36 am

Although Mosaic's Chroma software can process gcode produced by S3D, I would also like to see support for the Mosaic Palette 2 within S3D itself, specifically:

1) An option to see filament length consumed in print preview between layer/line markers (maybe a sliding adjustable bar to pick starting/end points). This would make pattern mode, gradient mode, etc. for the Palette 2 much more easier to use to get the desired output.
2) Assign colors for print preview per toolhead to get a more accurate representation of the output.
3) An additional option to launch an external app with the gcode filename as a parameter instead of "Save toolpaths to disk".

Some more non-Palette related:
4) Ability to create a master template process with certain parameters locked down in child processes. Then a workflow to create child processes based on the master template.
5) Support for speed advance setting for retractions (see this article: ... racts.html)

Posts: 12
Joined: Fri May 25, 2018 11:42 am

Re: Mosaic Palette2

Wed Feb 13, 2019 1:23 pm


Posts: 445
Joined: Wed Jun 20, 2018 11:45 am

Re: Mosaic Palette2

Wed Feb 13, 2019 4:06 pm

Great ideas guys! Thanks for your excellent feedback. As was already stated, their software already works well with post processing our G-code files. I'll keep an eye on this thread to see what new ideas and interest is generated by our community.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Feature Requests”